Custom Offset-Groove Stepped Copper Busbar
Video
Short Description
Custom copper busbar with an asymmetric stepped section and a wide, shallow offset groove. Section dimensions, material grade, finish and tolerances can be specified against the customer’s drawing.
Product Overview
This offset-groove copper busbar features a broad flat section, a shallow recessed channel and stepped side geometry. It can be considered for custom conductor joints or equipment assemblies where the profile is designed to match mating components.
Material and production route depend on the drawing, quantity and application. Cymber Metal supplies pure copper products and can review options for custom copper profile extrusion.
Key Features
The stepped profile and offset groove provide geometry for a drawing-specific interface or mounting arrangement. Fit, contact resistance, current capacity and any solder-stop function depend on the final design, material, surface condition and assembly validation.
Manufacturing & Quality Control
| Stage | Process / Control |
|---|---|
| Drawing Review | Confirm groove location, step heights, section thickness, mating surfaces and critical tolerances |
| Material Selection | Select copper grade and condition to match the specified electrical and fabrication requirements |
| Profile Production | Extrusion, drawing, rolling or machining may be considered based on the cross-section and order quantity |
| Finishing | Cut to length and apply specified surface treatment or plating where feasible |
| Inspection | Inspect agreed dimensions and surface requirements; additional electrical or material checks by agreement |
For drawing-defined secondary work, see copper machining support. Inspection scope and records are agreed before production; see the quality assurance page.
Typical Applications
| Application | Potential Use |
|---|---|
| Switchgear | Custom stepped conductor or connection profile, subject to equipment design |
| Power Modules | Copper base or conductor interface where the drawing specifies the stepped section |
| Battery & Power Distribution | Profiled conductor for a customer-defined transition or connection |
| Transformers & Rectifiers | Custom copper conductor component, subject to electrical and thermal review |
FAQ
It is a copper conductor with a shallow groove positioned off-center and one or more stepped surfaces. The final section is designed to suit the intended assembly.
C11000, C10200 and C10100 may be considered. Confirm the grade, material standard and required condition when submitting the drawing.
The route depends on the section geometry, dimensions, tolerances and order quantity. Extrusion or drawing with secondary machining can be evaluated during technical review.
Not by itself. The fit depends on the mating-part dimensions, tolerances, flatness and assembly method; confirm the joint design through drawing review and validation.
That function should not be assumed from the geometry alone. If solder control is required, specify the joining process and validate the groove design for that assembly.
The ranges in the specification table are indicative. Share the required cross-section and length so manufacturability can be checked.
Silver, tin or nickel plating may be reviewed if suitable for the application and profile. Specify the required coating, coverage and dimensional allowance.
A current rating cannot be determined from the product photo alone. It depends on the copper grade, section area, contact design, installation and operating conditions.
Request a Quote
To request a quotation, send the cross-section drawing, copper grade, dimensions, critical tolerances, material condition, surface treatment, quantity, application and documentation requirements.










